Instructions for installing a fence made of welded mesh with a polymer coating
Installation of mesh fences as a standard does not cause difficulties with self-assembly. Production is organized in such a way that all products have standard, clear dimensions, poles , sections and fixtures.
The fencing kit includes:
- Pillar
- Section
- Fixing kit ( bracket , bolt )
The sequence of installation of the mesh fence
- Make holes in the ground every 2.50 m with a diameter of 25 -35 cm and a depth greater than the depth of soil freezing for your area.
- Installation of welded mesh on poles , this product is recommended to be made before concreting the poles and assembling the sections on the ground. Lay two posts parallel to each other on a flat surface, with the attachment points facing up.
- Lay the railing section on the posts and attach it to the posts using the fasteners that come with the posts at the top and bottom points as shown in the images below:
- Raise the assembled section, lower the bottom of the posts into the dug holes, and support the section with pre-prepared boards or spread it with twine and driven stakes. Under the bottom of the section, place small beams intended for leveling in height.
- The fifth stage will be the assembly of the following sections, from one to four sections, with the subsequent connection with the already installed part of the fence . After ten fifteen sections are installed, you can start concreting.
IMPORTANT! Installation of fencing sections made of welded mesh with PVC coating , which at the first stage involves concreting the pillars, followed by hanging fence sections, involves digging holes for concreting with a clear step of 2505 mm, in the centers.
Attention! Poles for use at corners are not provided in this model of the fence . It is recommended to install two poles or fasten the mesh using self-tapping screws and a standard fastening bracket .